It can be irritating when your iPhone dies and won’t charge, especially if you need it for something important. Luckily, there are several ways to try and get your device back up and running before seeking professional help.
First, check the charging cable and adapter for damage. Then, clean the charging port to remove any dust or debris. You can also perform a hard reset on the iPhone. If these steps don’t work, try charging your iPhone in a different outlet or using a wireless charger. If the problem persists, you may need to replace the battery or visit an Apple service center. These steps will guide you through fixing your iPhone, which has died and won’t charge.
Steps to Fix an iPhone That Died and Won’t Charge
Here are the easy steps to fix the iPhone that is dying and won’t charge:
Step 1: Check the Charging Cable and Adapter
When your iPhone dies and won’t charge, the first thing to do is check the iPhone’s charging cable and adapter. Over time, charging cables can fray, bend, or get damaged, especially at the connectors.
Look for visible signs of wear on the cable or adapter, such as fraying, exposed wires, or bent connectors. If the cable or adapter looks damaged, try using a different one that’s in good condition. Sometimes, a faulty cable is all it takes to prevent charging.
Step 2: Clean the Charging Port
Dust, lint, or dirt inside the charging port can prevent the iPhone from charging properly. To clean the charging port, start by turning off your iPhone. Use a small, soft, or antistatic brush to remove debris from the port gently.
You can also use a toothpick, but be careful not to damage the internal components. Avoid using compressed air, which could push dirt further into the port. After cleaning, try charging your iPhone again.
Step 3: Force Charge for 30–60 Minutes
If the battery is deeply drained, it may take longer to respond. Connect your iPhone to a wall charger (not a computer), leave it plugged in for at least 30 minutes, and do not try to turn it on during this time. Sometimes the battery is so empty that the phone needs time before even showing the charging icon.
Step 4: Try a Different Outlet or Charger
Sometimes, the issue could be with the power source itself. Try plugging your iPhone into a different wall outlet or using a different charger to rule out the possibility of a faulty power source.
If you use a USB port on a computer or laptop, use a wall charger instead. In some cases, USB ports on computers might not supply enough power for charging. If the iPhone charges in a different outlet or with a different charger, your previous power source might be the issue.
Step 5: Use Wireless Charging (If Available)
If your iPhone supports wireless charging, try using a wireless charger. Place your iPhone on a compatible wireless charging pad and wait for it to start charging. If it charges wirelessly but still won’t charge through a wired connection, there may be a problem with the Lightning port or charging cable. If wireless charging works fine, but your iPhone still won’t charge via cable, you may need to replace the charging port or cable.
Step 6: Inspect for Signs of Water or Physical Damage
If your iPhone got wet recently or was dropped, internal damage may prevent it from charging or turning on. Look for signs like discoloration in the charging port or screen flickers. If water damage is likely, do not attempt to charge further; take it to a repair technician immediately.
Step 7: Replace the Battery or Seek Professional Help
If none of the above solutions work, it’s possible that your iPhone’s battery is faulty and needs to be replaced. Over time, batteries lose their ability to hold a charge, especially after a few years of use.
If your iPhone is still under warranty or covered by AppleCare, contact Apple for support. A professional repair service can replace the battery if you’re out of warranty. If you suspect a hardware issue beyond the battery, visit an Apple service center for a thorough diagnosis.
Conclusion
When your iPhone dies and won’t charge, you can fix the problem with simple steps. Start by checking the charging cable and cleaning the port. If necessary, perform a hard reset and try charging in different outlets or use a wireless charger.
If these steps don’t work, a battery replacement or professional repair might be required. By following these methods, you can often solve the “iPhone died and won’t charge” issue on your own. If you need professional help, contact GadgetFix for expert iPhone repair services today!