If you drop your phone in water or it gets wet, you must act quickly to prevent damage, especially to the charging port. Dealing with a water-damaged charging port can be stressful, but don’t worry, there are several good ways to handle this common issue.
To remove water from the charging port first, carefully dry the port on your device by gently shaking off any extra water. Putting your phone at the right angle and letting gravity work for you can make a big difference. Taking out parts, like SIM cards, that might trap water can also help. Also, make sure the outside of your phone is completely dry, and finally, give your device enough time to dry out completely before you try to charge it again.
7 Tips to Remove Water From the Phone Charging Port
Here’s what you need to do:
1. Shake the Device Gently
First, give your phone a light shake. Hold your phone so that the charging port is facing downward. Any extra water will be able to drain out. But be careful not to shake it too hard, because that could hurt what’s inside.
2. Dry the Port
After shaking the charging port, gently wipe the area around it with a clean, dry cloth to clean a phone charging port safely. Avoid pushing the cloth too far inside, as this could force water deeper into the device and cause further damage.
3. Let Gravity Help
When it comes to drying out your phone, gravity is great. Place the device on a flat surface at a right angle so the charging port faces down. Allow any water to drain naturally for some time.
4. Dry the Exterior
When you dry the port, remember to dry the phone’s outside, too. Wipe the phone down with a dry cloth to remove any water that got on its surface.
5. Wait and Let It Evaporate
After following the above instructions, if your phone still has water on it, put it in a safe place and dry it. Take your time; it’s crucial to ensure the port is dry.
6. Check If It Still Functions
After allowing the water to evaporate, check the charge port. Plug your charger into the port to ensure it is functioning properly. If your phone charges regularly, you’re set to go.
7. Seek Professional Repair
If drying doesn’t solve the issue, visit a phone repair expert. They can safely remove hidden moisture and prevent internal damage. Avoid using the port until it’s professionally checked.
5 Additional Tips for Drying the Charging Port
You may also lessen the chance of harming your device and assist in drying out the charging port by adhering to some other helpful tips:
- Place Near a Fan: Place your device near a fan or soft, moving air source. This will facilitate air flow and help remove water from the charging port.
- Use a Vacuum Cleaner: A vacuum cleaner with a small tool can gently pull out any still water at low suction.
- Use Silica Gel Packets: Putting your device in a sealed bag with silica gel will lower humidity, helping it dry faster.
- Desiccant Packets: Other desiccant packets often found in shoe or gadget packaging can also absorb moisture in the same way that silica gel packs do. Put your device in a sealed packet/bag with these packets inside.
- Specialty Drying Bags: Buy a special drying bag made just for gadgets. These bags dry out wet electronics, often with beads that soak up water.
3 Mistakes to Avoid When Drying Your Phone’s Charging Port
When removing water from the charging port, you should avoid using these practices:
- Avoid Using Heat: Avoid using a hair dryer or placing your phone in direct sunlight, as too much heat can damage your phone’s internal parts.
- Do Not Shake Hard or Blow (Including Compressed Air): If you shake the phone vigorously or use compressed air, water may penetrate further into it and potentially cause more harm.
- Avoid Inserting Objects Like Cotton Swabs, Paper Towels: Cotton swabs or paper towels put into the charge port can damage the inside or cause lint to build up.
Conclusion
If you accidentally spill water on your phone, acting quickly to prevent damage is crucial. A little care and quick action can make all the difference in keeping your phone functioning. Remember to carefully follow these steps after you know how to remove water from your phone’s charging port so you don’t damage it.
Once you’ve dried out the port and given the device a gentle shake, check to ensure the water is completely removed. If you still notice moisture, put it near a fan or use silica gel packets to dry your phone faster. But be careful not to use heat sources or put anything (cotton swab/paper cloth) in the port. If the problem persists, please call GadgetFix for dedicated phone repair services and expert care.
